Sakura HBK-18?23AB Manuál s instrukcemi stáhnout pdf (Strana 7)

connected together. Two short lengths of the small diameter

shrink-wrap about ½" (13mm) long should be cut from the

2” (5 cm) piece supplied, to insulate the soldered joints.

Shrink-wrap is a special rubber tube, which reduces in

diameter when heated. To use it, first slide it over the end of

one of the two wires to be joined then, after the wires are

soldered together, slide it back to cover the exposed joint and

overlap the insulation at little at each side.

Finally, rub the hot soldering iron over the shrink-wrap and it

will close tightly round the joint.

In order to set and adjust the linkages, the r/c equipment must

be connected up and batteries fitted.

The short lead from the switch should be plugged into the

receiver in the socket typically marked (B) or BATT. The other

lead with the PP9 clip then attaches to the battery holder. For

now, just lay the battery holder at the side of the loco; it will be

fitted to the body later.

The receiver will be housed between the frames under the

footplate area and retained by the chassis cover plate

supplied with this kit.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Žádné komentáře

Sakura HBK-18?23AB Manuál s instrukcemi Strana 7